Pressure washer setup
1- connect garden hose to unit
2- connect Pressure hose to gun and unit
3- be sure to have a tip in the gun
4- turn on the water to full
5- pull the trigger on the gun until air is out of system
6- if engine is cold set choke to on (right), if warm set choke
to off(left position)
7- turn throttle to idle (far right)
8- turn kill switch to on position
9- while pulling trigger on the gun pull the rope to start the engine
10- work choke off (left position)
11- slide throttle to at least 3/4 throttle (far left position)
12- you can now release the gun trigger and you are ready to work
