Shed Repair

It was time to do something about the shed. the front corner seemed to be sinking. The doors were all crooked. And i could see light through the walls. But once I opened this can of worms The extent of damage was worse than i thought

First Noticed the doors were uneven and getting hard to close

vvvvvvvvvvvvvvvvvvvvvvvvvvvvvSo I attempted to lift the front corner to place blocks under it and bring it up to level

When i tried to put a jack under the side i noticed there was nothing there to jack against

looking on the inside of the shed it didn’t look too bad

Looking a little closer i could see some of the sill plate was missing

so i looked closer to find out there was part of the frame of the floor missing

I was able to slide a second 4×4 skid under to sister against the old one

looking from the outside where i tried jacking the shed up there was nothing there but siding

I started removing what i could by hand and started realizing that not only was there no sill plate of side frame there were no joists at the end

I cut some flooring out of the way to reveal that the joist were all rotted off

Sistered in new joists

Rebuilt the side of the floor

As i worked my way around to the back wall i found the same issue along the bacl of the shed. the walls were just hanging with no sill plate

Replaced the joist and added a ill plate. added straps at the wall studs to hold them in place and make them easy to replace later

closed it up to keep the critters out

Tool Boxes finally back in place

Slowly getting things back in order.