Nancy’s Kitchen

I’m building some kitchen cabinets as a gift for my sister so I figured I would show some of Them. This is my first time building kitchen cabinets so be kind. I’m not perfect.

BEFORE
Current Progress
It all Started With a New table saw
And Some wood waiting to be cut
Wood ready on my lumber cart(I Made)
I really find my cart usefull
First carcass attempt. I put the pocket screw on the top oops
Put the pocket screws on the bottom where they belong
Cabinet is too wide
Narrowed the cabinet
Carcass ready
Front face all built
Dry fitting a drawer
Drawer without Vernier Strip
Drawer With Vernier Strip
Started with the top drawer
All set in ruff fit
Top Drawer -Notice I used dry erase board for the drawer bottoms to allow for easy cleaning
Drawer #2 – Was tight on the slides but I clearanced out the side mounts now it slides fine
Drawer #3
Drawer #4
Drawer test fit no slides
Drawer test fit. no slides
Test fit for drawers
Initial Mock up assembly of the first caninet. just to make sure everything fit.. I know the drawers are a little crooked but they got pulled apart to be sanded and stained
Before
Upper Cabinet Stained and ready for doors

Hidden Drawer Installed
Boards cut for Over Sink Cabinet
About to start assembly of Over sink cabinet
Top two Shelves done
Stringers Installed
All ready to go on the wall
All ready to go on the wall
Shelving under sink right side done
The Pantry Build Begins
This thing barely fits on my bench
Upper Cabinet Door Frames Are Stained and ready for assembly
Door Assembled
Door Glue Drying
Doors hung
upper cabinet doors hung
Upper doors hung
Upper doors hung
The Pantry Build Begins
The parts inside the pantry do not belong to the pantry build
Metal heat shield Installed for microwave
Heat shield in and microwave ready for test fit
Microwave fits perfect
Microwave Hidden table Installed
Installed the under sink back panel to cover most of the plumbing
Hung her brushes on the right side of the cabinet
Installed the back nailer for the backsplash
Another look at the Backsplash Nailer. the board was nothched 1/4 x 1/4″ to keep it aligned with the countertop
Cody puts the first backsplash up on the back wall
Cody Installed the lights
Wall One looks good
Print Friendly, PDF & Email